NTP Server Static GPS Antenna Systems
The Global Positioning System (GPS) is often hardware, such as NTP Server systems used to provide an accurate time reference for time-critical applications. This article gives an overview of GPS for timing applications and describes the equipment used to install a GPS antenna to a fixed location. Overview – GPS for accurate time The Global Positioning System is a U.S. military global navigation. The system consists of 24 satellites in orbit, each satellite has a highly accurate atomic clock on board to synchronize the UTC. The satellites continuously broadcast position and time information. The time and position information available in the world with a GPS receiver and antenna. GPS works continuously in conditions so all over the world. In addition, there is no setup fee or subscription fees using fixed GPS systems. Many computer timing systems and NTP Server systems use GPS as a precise external timing reference. The precision of GPS timing system GPS receivers provide highly accurate position and timing information. Typically, a GPS receiver providing position information with an accuracy of 15m. NTP server systems may receive timing information from GPS to a resolution of a few nanoseconds. The GPS signal The information transmitted GPS signal is very low, low-power radio signal, called L1 and L2. L1 GPS frequency is transferred to the 1575th Civilian 42 MHz. The signals travel by line of sight and can through clouds, glass and plastics are blocked by objects such as metal and masonry. Therefore, the ideal place for a GPS antenna on the roof with a 360 degrees on the sky. However, often the installation on the side of a building or in a window can provide adequate results. In general, the larger view of the sky, the more likely a good signal to lock online. Types GPS Timing Antenna The GPS antenna acts as an amplifier for amplifying the GPS signal for transmission to a cable, coaxial rule adopted by the GPS receiver. Timing GPS Antenna with NTP server systems use a pole mounting system available. The screws with a threaded rod antenna must be installed on rooftops. This arrangement allows the GPS antenna with a rigid easily able to withstand strong winds without damage. Typically, the GPS antenna is very low, less than 90cm in diameter. Low-cost patch antennas type are also available, but these applications are generally more appropriate vehicles. GPS antenna cables and cabling distances The length of cable that can be used by a GPS antenna depends mainly on strengthening the quality GPS antenna and coaxial cable used in the factory. A typical GPS antenna calendar may have a gain of 35 dB. RG58 coax a relatively low quality as an attenuation of 0. 64 dB / m at 1575 MHz. can run a 55m cable with RG58 cable. work with high quality coaxial cable, as LMR400, a 200m cable can be made simple. However, very high quality coax can be expensive. A good compromise between price / performance is the LMR200 cable, which can be executed without foreign aid to 80m. Develop wiring distance GPS Line Amplifier provide inline amplifier for further amplification of the GPS signal in order to increase the cable distance between the GPS antenna and receiver. GPS-amplifiers are mounted in line with the antenna cable and receive power from the receiver via coaxial cable. No external power is required. Typically, an amplifier GPS Add an additional gain of 20 dB, adding 30 feet of RG58 coaxial low quality coax 40m or 100m LMR200 LMR400 Coaxial quality. In addition, several line amplifiers are used to increase the length of cable to be later. Sharing a single antenna between several receivers – GPS Splitter GPS splitters allow a single GPS antenna by two or more systems of NTP servers are used. The GPS-splitter divides the signal from the GPS antenna in several outputs for synchronizing multiple NTP servers receive. GPS splitter are generally available with 2, 4 or 8 outputs. The protection of GPS – GPS Surge surge suppressors protect expensive equipment NTP server from static discharge such as lightning, which can be sensed by a GPS antenna mounted outside. Surge in online via the coaxial cable between the antenna and receiver, ideally when the cable installed in the building. surge suppressors require a low floor to surge possibly preserved. The climb requires no additional power or wiring.
Farewell paper mapLong live the GPS! In recent years, navigation systems have made their entry into force in the passenger cars, relegating the big road atlas at the bottom of glove boxes, to make way for a bright color screen interactive. There are three types of GPS: